The Surround Setup Menu; Making Receiver Settings From The Surround Setup Menu - Pioneer Elite VSX-56TXi Operating Instructions Manual

07

The Surround Setup menu

Chapter 7
The Surround Setup menu
Making receiver settings from the
Surround Setup menu
This receiver allows you to make detailed settings to
optimize the surround sound performance. You only
need to make these settings once (unless you change the
placement of your current speaker system or add new
speakers.).
These settings are designed to fine-tune your system, but
if you're satisfied with the settings made in Automatically
setting up for surround sound on page 12, it isn't
necessary to make all of these settings.
Important
• For some of the settings below, you'll have to connect
the setup microphone to the front panel and place it
about ear level at your normal listening position. See
Automatically setting up for surround sound on
page 12 if you're unsure how to do this. Also see
Other problems when using the Auto Surround Setup
on page 14 for notes regarding high background
noise levels and other possible interference.
• If you're using a subwoofer, switch it on and turn up
the volume to the middle position.
• After three minutes of inactivity during the Auto
setup options, the OSD will go to sleep until a button
is pressed. With other screens, the receiver
automatically exits and no settings will be made.
Caution
• The test tones used in the Surround Setup are output
at high volume (the volume increases to 0db
automatically).
1 Switch on the receiver and your TV.
Use the RECEIVER button to switch on.
• If headphones are connected to the receiver,
disconnect them.
50
En
2 Using the remote control, press RECEIVER, then
press the SYSTEM SETUP button.
An on-screen display (OSD) appears on your TV. Use the
(cursor up/down) buttons and ENTER on the remote
control to navigate through the screens and select menu
items.
SYSTEM SETUP
Tip
• You can also use the front panel display to make
settings. You can also use the MULTI JOG dial and
ENTER on the front panel instead of the
up/down) buttons and ENTER on the remote control.
3 Select 'Surround Setup' then press ENTER.
System Setup
[ 1. Surround Setup
[ 2. THX CINEMA Setup ]
[ 3. Input Assign
[ 4. Function Rename
[ 5. SACD Setup
[ 6. PHONO/LINE Setup ]
[ 7. Multi Room
[ 8. 12V Trigger
[ Exit
4 Select the setting you want to adjust.
1.Surround Setup
[ SurrBack System
[ Auto Setting
[ Normal
[ Expert
[ Exit
RECEIVER
RECEIVER
ENTER
(cursor
]
]
]
]
]
]
]
]
]
]
]
]