Install Blower - NuTone ROOMSIDE AERN110SLW Installation And Use & Care Instructions

9. Install blower.

Re-install blower. Secure blower with 2 screws from parts bag and plug
blower into black receptacle.
• Make sure that the wiring inside of the housing
does not interfere with re-installation of the blower.
10. Finish ceiling, then install grille.
Attach MOUNTING PLATE to housing with (2) SCREWS.
Connect LIGHT PANEL PLUG to receptacle in corner of housing.
Place LIGHT PANEL SLOT over HOOK on MOUNTING PLATE.
Swing opposite side of LIGHT PANEL up to MOUNTING PLATE and
secure with ATTACHMENT SCREW.
Line up GRILLE FRAME with (3) LIGHT PANEL OPENINGS and
rotate GRILLE FRAME clockwise to secure it to LIGHT PANEL.
HOOK
LIGHT PANEL
PLUG
SLOT
LIGHT
PANEL
OPENING (3)
GRILLE
FRAME
6
CAUTION
MOUNTING
PLATE
MOUNTING
PLATE
ATTACHMENT
SCREW (2)
LIGHT
PANEL
ATTACHMENT
SCREW
RETROFIT
5. Remove old fan.
Enlarge ceiling opening (if necessary)
to 9¾" parallel to joist) by 10½"
(perpendicular to joist). Leave ductwork
and wiring in place.
1
10½-in.
9¾-in.
6. Fold mounting ears flat
against housing.
JOIST
2