Hunter Newsome Installation Manual page 7

1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Repeat x2
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket Hanging Fan
2 of 6
Light Kit Screw
bag
5
Partially install two of the light kit screws
found in the hardware bag. Align the
notches in the sides of the lower switch
housing with the screws on the upper
switch housing. Twist the lower switch
housing clockwise to lock into place.
Installing the Bulbs and Glass
Note:
and click "How do I install my
Fan style may vary.
Wiring
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
2 of 6
Light Kit Screw
bag
Motor Housing
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
bag
Install the last light kit screw.
Tighten all three screws securely.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Press the globe and globe
keeper flush against the metal
plate. Thread the light pull chain
through the hole in the center of
the finial cap and thread the fan
pull chain through the hole in the
side of the cap. Finally, thread
only the light pull chain through
the hole in the finial and screw
the finial onto the threaded rod.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
1886
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
ON
6
Light