Simulating A Route; Starting Navigation - Pioneer AVIC-S1 User Manual

User's manual AVIC-S1
4.5.8

Simulating a route

Simulation
Condition
Stop simulation
4.5.9

Starting navigation

Overview
Condition
- 62 -
You can also simulate a navigation.
Note: You do not need GPS reception in order to simulate a
route.
Only routes of max. 60 miles in length can be simulated.
You have planned or downloaded a route as described in
"Indicating waypoints" on page 56 and "Load route" on page
59.
The route is calculated as described in "Calculating the route"
on page 60 and is shown on the map.
1. Touch the Simulation button.
The route is recalculated for the simulation.
After the calculation the simulation starts.
The simulation can be ended at any time.
1. Press the MENU key beneath the display.
2. In the D
ESTINATION
3. Touch the Cancel Route button.
When the GPS signal is sufficient for navigation purposes, you
can start route guidance.
Note: During navigation the current position is the starting
point. The first stage is then the drive to the first specified
waypoint.
Note: The route calculation uses the settings that were
established in the R
can change the standard settings via the S
P window. You will find detailed information on
REFERENCES
this in chapter "Route Preferences" on page 86.
You have planned or downloaded a route as is described in
"Indicating waypoints" on page 56 and "Download route" on
page 59.
The route is calculated as described in "Calculating the route"
on page 60 and is shown on the map.
window, tap on the To the right button.
P settings window. You
OUTE REFERENCES
Itinerary (with waypoints)
– R
ETTINGS OUTE