Before Using; Checking Accessories; Preparing The Remote Control - Pioneer Elite DV-C36 Operating Instructions Manual

Before Using

Checking Accessories

Please confirm that the following were received with the
player.
Audio cord
Video cord
Power cord
Remote control unit
AA (R6P) dry cell batteries
Operating instructions (this manual)
8
5
5

Preparing the Remote Control

Inserting batteries into the remote
control
1
While pushing the tab on the battery
compartment cover
toward the center of
the remote, pull out
in the direction
indicated by the
arrow.
2
Insert batteries.
Make sure to match the
plus (+) and minus
(–) polarity guides on
the batteries with the
marks inside the
battery compartment.
3
Close the cover.
Notes
• Do not mix old and new batteries.
• When replacing batteries, use all new batteries.
• When not using the remote control for a long period of time
(over 1 month), remove the batteries to avoid possible
damage from battery corrosion. If battery leakage occurs,
wipe the battery liquid from the battery component, then
insert new batteries.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country or area.
Remote control operation
When operating the remote control, point it at the
remote sensor (Î) located on the player's front panel.
The remote control can be used up to 7 m (23 feet) from
the player and within a 30° angle on each side of the
sensor.
30
30
7m (23ft.)
Notes
• Exposing the remote sensor to direct sunlight or strong
light may cause faulty operation.
• If the CONTROL IN jack on the player's rear panel is
connected to the CONTROL OUT jack of another
component, point the remote control at the other
component to operate the player. Operation will not be
possible when pointed at this player (page 17).