Quick Installation - ViewSonic VX2771-smhv-2 User Manual

Quick Installation

1. Connect video cable
• Make sure both the display and computer are turned OFF.
• Remove rear panel covers if necessary.
• Connect the video cable from the display to the computer.
Macintosh users: Models older than G3 require a Macintosh adapter. Attach the
adapter to the computer and plug the video cable into the adapter.
To order a ViewSonic
2. Connect power cord (and AC/DC adapter if required)
Power Cord
Audio Out
3. Turn ON the display and computer
Turn ON the display, then turn ON the computer. This sequence (display before
computer) is important.
NOTE: Windows users may receive a message asking them to install the INF
file. To download the file, visit the "Download" section of the monitor product
page on the ViewSonic website.
4. Windows users: Set the timing mode (example: 1024 x 768)
For instructions on changing the resolution and refresh rate, see the graphics
card's user guide.
5. Installation is complete.
Macintosh adapter, contact ViewSonic Customer Support.
®
Enjoy your new ViewSonic
4
HDMI
D-Sub
display!