Usb Multimedia; Viewing Pictures; Troubleshooting - Element ELEFT222 Instruction Manual

USB MULTIMEDIA

Viewing Pictures

• Press the SOURCE button on the
main unit or on the remote control
then press the
the USB mode and then press OK
button.
• Press the
photo and then press OK button.
File format supported: JPEG.
Operation Tips
Press to start or pause the photo playback.
Press to stop photo playback.
Press to view the previous photo.
Press to view the next photo.
REPEAT Press to select different repeat mode.

Troubleshooting

If your TV does not operate normally or cannot be turned on, please check
the following troubleshooting questions. Remember also to check any other
connected electronic device, such as DVD or blu-ray player to pinpoint the
problem. If the TV still fails to operate normally, please contact technical support
(Refer to Warraty page).
SYMPTOM
Dead. No LED lit
Dead. No LED lit red
Blue screen
Noisy, snowy, ghosting
picture(TV)
No sound
22
buttons to select
buttons to select
POSSIBLE CAUSE
No power to the TV.
Set in standby mode.
No signal.
Incorrect
source selected.
Poor antenna signal.
Sound "Mute".
Volume set too low.
External leads
not connected "if used".
Phot
C:
..
2010100.jpg
2010101.jpg
2010102.jpg
2010103.jpg
002/005
Play File :0
Total size:3.8 GB
Unused size:3.7 GB
REMEDY
• Check all connections to the
TV's AC socket.
• Press either the Power button
or the Standby button on the
remote control.
• Press the SOURCE button to
select the correct source.
• If using an indoor antenna, try
adjusting the antenna position.
Check antenna connections.
• Turn sound "Mute" off.
• Check volume settings.
• Check that all external leads
are connected properly.
USB
C:\PICTURE\
2010100.jpg
1024 x686 229.0KB
Select Move Repeat