Installing The Microphone; Using The Wired Remote Control; Using The Rear View Camera - Sony XAV-1500 Operating Instructions Manual

When the positions of the red and yellow
leads are inverted
Red
Yellow
12 switched power supply
continuous power
15
supply
For cars without ACC position
Red
Yellow
After matching the connections and switching
power supply leads correctly, connect the unit to
the car's power supply. If you have any questions
and problems connecting your unit that are not
covered in this manual, consult the car dealer.

Installing the microphone

To capture your voice during handsfree calling, you
need to install the microphone .

Clip (not supplied)
Red
Yellow
Yellow
Red
Red
Yellow



Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base  to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.

Using the wired remote control

1
To enable the wired remote control, set
[Steering Control] in [General] to [Preset].

Using the rear view camera

Installation of the rear view camera (not supplied) is
required before use.
The picture from a rear view camera connected to
the CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
13
GB