Table of Contents
Advertisement
Notes
• The camera name (NAME) is to be up to 8
characters of alphanumeric characters and
spaces.
• The camera's IP address of the network setting
and camera name cannot be changed when
WRITE of Inquiry reply is set to off.
• WRITE turns to off automatically when 20
minutes have passed after turning on the
camera and does not accept the network
setting.
• Turning WRITE to off using the CGI command is
also possible. When turning to off with the CGI
command, the camera does not accept the
network setting soon after turning on the
camera. Improper changes can be prevented
by turning WRITE to off after setting the IP
address of the camera.
CGI
Advance Preparation
This document provides information about how
to control this camera remotely via network and
stream video/audio by using CGI commands
supported by this camera and RTSP function.
To use CGI commands and RTSP streaming
function, some pre-configurations are required.
These pre-configurations are described below.
IP Address Settings by RM-IP Setup Tool
To enable the device to communicate with the
camera appropriately, IP address settings is
required. Set IP address based on your network
environment using RM-IP Setup Tool. For details,
refer to "RM-IP Setup Tool Guide."
Note
To set IP address via Admin menu on Web
browser, refer to "Network tab" under "Network
menu" in Operating Instructions.
Setting the Initial Password
Setting the administrator's password is required
when operating this camera for the first time.
Access to the cameras using Web browser. To
access, enter the IP address of the cameras to
the address bar in the Web browser, then press
Enter.
Entering the user name and password is
required. Enter the administrator's user name
and leave the password blank for the first login.
Admin username: admin
Password: blank space
When you log in, setting of the administrator's
password is required.
The following letters are available for passwords.
Set 8 to 64 characters for the password including
alphabetical capital letters, lower case letters,
and numbers.
• Alphanumeric
• Symbol (!$%`*+-./<=>?@[]^_{¦}~)
When you press "OK," the user setting will be
changed. Once the setting is changed, you will
be requested to enter admin username and
password again. Enter the admin username and
password you changed in the previous step.
30
Advertisement
Table of Contents
