Download Print this page

Advertisement

Quick Links

DBS
ASSEMBLY
INSTRUCTION
Contents
Instructions
User Manual
Cautions
support@neochair.com
www.neochair.com
※Please make sure all the parts are included.
Missing parts?
BACK X1
WHEEL X5
Read the instructions carefully.
(-H)
support@neochair.com
SEAT X1
ARMREST X2
BASE X1
BASE LEG X1
CONTROL
MECHANISM X1
Headrest models comes with below part
HEAD REST X1
HEAD REST BOLT
Please follow the assembly steps.
GAS LIFT
CYLINDER X1
E
X2
A
X10
(SEAT + BACK
ARMREST)
B
X4
(LOCKING)
C
X10
(WASHER)
D
X1
(ALLEN KEY)

Advertisement

loading

Summary of Contents for Neo Chair DBS

  • Page 1 (-H) ASSEMBLY INSTRUCTION Contents Instructions User Manual Cautions support@neochair.com www.neochair.com ※Please make sure all the parts are included. Missing parts? support@neochair.com (SEAT + BACK ARMREST) (LOCKING) CONTROL GAS LIFT BACK X1 SEAT X1 ARMREST X2 CYLINDER X1 MECHANISM X1 (WASHER) Headrest models comes with below part (ALLEN KEY) BASE X1...
  • Page 2 Instructions TIPS! ※NOTICE Please use the allen key included instead of an electric drill. Use the box for an easier assembly. STEP 1 Bottom BASE LEG X1 Press the base leg until you hear "CLICK." Insert the base leg vertically into the base. WHEEL X5 Ouch! Be careful not to get...
  • Page 3 Make sure to turn the base over. STEP 2 Insert gas lift cylinder into the center of the base. For proper alignment: Slightly under-tighten the bolts. For proper alignment: Slightly under-tighten the bolts. BACK X1 ARMREST X2 Line up the armrest and the back. Put the armrest on the bottom Loosely tighten with two bolts.
  • Page 4 fully tighten x 10 FRONT Once all of the armrests bolts are in place, Match the front stickers and fully tighten every bolt. secure the Control Mechanism to the seat. STEP 3 This step is only for a model with headrest HEAD REST X1 Mount the seat onto the gas lift cylinder...
  • Page 5 User Manual Check Tension Right hand Adjustment Tilt Lumbar Down Tilt Tension Height Down...
  • Page 6 To deodorize your new chair For longer use leave the chair in a well Re-tighten bolts every 6 months by using ventilated area for 1-2 days the enclosed allen-key. *Using an electric drill can damage the chair. Please re-tighten bolts manually. Cautions DO NOT DO NOT...

This manual is also suitable for:

Dbs-h