Husqvarna K6500 Chain Operator's Manual page 16

• Stand parallel to the guide bar. Avoid standing straight
behind. In the event of a kickback the saw will move in
the plane of the guide bar.
• Keep all parts of your body away from the rotating
diamond chain.
• Never leave the machine unsupervised connected to
the power source.
• Never move the machine when the cutting equipment
is rotating.
• Never lay the power tool down until the accessory has
come to complete stop.
• Never use the kickback zone of the bar for cutting.
• Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory
which may cause loss of control or kickback. See
instructions under the heading "Kickback".
• Keep a good balance and a firm foothold.
• Never cut above shoulder height.
• Never cut from a ladder. Use a platform or scaffold if
the cut is above shoulder height.
• Do not overreach
• Stand at a comfortable distance from the work piece.
• Always ensure you have a safe and stable working
position.
• Check that the cutting equipment is not in contact with
anything when the machine is started.
• Apply the chain gently with high rotating speed (full
throttle) Maintain full speed until cutting is complete.
• Let the machine work without forcing or pressing the
chain.
OPERATING
• Feed down the machine in line with the bar and cutting
chain. Pressure from the side can damage the bar and
the cutting chain and is very dangerous.
• Move the cutting chain slowly backwards and forwards
to give a small contact surface between the cutting
chain and material to be cut. This will mean the cutting
chain temperature is kept down resulting in efficient
cutting.
In principle there are two ways to start the process of
entering a thick object to be cut.
Plunge-cut method
• Start by making a 10 centimetre deep cut in the wall
using the lower part of the tip of the bar. Straighten up
the saw at the same time as the tip of the bar is
inserted in the slot. Raising and lowering the saw at
the same time as it is pressed into the wall provides an
effective method of cutting to the full depth.
–
English 15