Pico Macom CA-30RK550 Installation And Operation Manual page 3

550mhz push-pull headend amplifier
Hide thumbs Also See for CA-30RK550:
Table of Contents

Advertisement

CA-30RK550 Manual.qxd
9/9/03
11.
Power Sources:
This product should be
type of power source indicated on the marking label. If you are not
sure of the type of power supplied to your home, consult your appli-
ance dealer or local power company.
12.
Power-cord Protection: Power-supply cords should be routed
so they are not likely to be walked on or pinched by items placed upon
or against them. Pay particular attention to cords and plugs, conven-
ience receptacles, and the point where they exit from the appliance.
13.
Lightning: For added protection for this product during a lightning
storm, or when it is left unattended or unused for long periods of time,
the unit should be disconnected from power source.
14.
Power Lines:
An outside antenna system should not be located
in the vicinity of overhead power lines, other electric light or power cir-
cuits, where it can fall into such power lines or circuits. When installing
an outside antenna system, extreme care should be taken to keep
from touching such power lines or circuits as contact with them may
be fatal.
15.
Overloading:
Do not
this can result in risk of fire or electric shock.
16.
Object and Liquid Entry: Never push objects of any kind into this
product through openings as they may touch dangerous voltage
points or short-out parts that could result in a fire or electric shock.
Never spill liquid of any kind on the product.
17.
Servicing:
Do not attempt to
opening or removing covers may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel.
18.
Damage Requiring Service:
outlet and refer servicing to qualified service personnel under the fol-
lowing conditions:
a. When the
power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects
c. If the product has been
d. If the product does not
ating instruction. Adjust only those controls that are covered by
the operating instructions. An improper adjustment may result in
damage and will often require extensive work by a qualified tech-
nician to restore the product to its normal operation.
e. If the product has been dropped or the cabinet has been
damaged.
f. When the product
this indicates a need for service.
19.
Replacement Parts:
sure the service technician has used replacement parts specified by
the manufacturer or have the same characteristics as the original
parts. Unauthorized substitutes may result in fire, electric shock or
other hazards.
20.
Safety Check:
Upon completion of
product, ask the service technician to perform safety checks to deter-
mine that the product is in proper operating conditions.
21.
Outdoor Antenna Grounding: Before attempting to install this
product, be sure the antenna or cable system is grounded so as to
3:01 PM
Page 3
CA-30RK550
operated only from the
overload wall outlets and extension cords as
service this product yourself as
Unplug this product from the
have fallen into the product.
exposed to rain or water.
operate normally by following the oper-
exhibits a distinct change in performance—
When replacement
parts are required, be
any service or repairs to this
Ph: 800-421-6511
wall
provide some protection against voltage surges and built-up static
charges.
a. Use
No.10 AWG (5.3mm) copper, No.8 AWG (8.4mm) alu-
minum, No.7 AWG (10mm) copper-clad steel or bronze wire or
larger, as ground wire.
b. Secure antenna lead-in and
off insulators spaced from 4 feet (1.22m) to 6 feet (1.83m) apart.
c. Mount antenna discharge unit as close as
lead-in enters house.
d. A
driven rod may be used as the grounding electrode where
other types of electrode systems do not exist. Refer to the
National Electrical Code, ANSI/NFPA 70-1984 for information.
e. Use jumper wire not smaller than
or equivalent, when a separate antenna grounding electrode is
used.
NOTE TO THE
THIS REMINDER IS
PROVIDED TO CALL THE CATV SYSTEM
INSTALLER'S ATTENTION TO ARTICLE 820-22 OF THE NEC
THAT PROVIDES GUIDELINES FOR PROPER GROUNDING
AND, IN PARTICULAR, SPECIFIES THAT THE CABLE
GROUND SHALL BE CONNECTED TO THE GROUNDING
SYSTEM OF THE BUILDING, AS CLOSE TO THE POINT OF
CABLE ENTRY AS PRACTICAL.
www.picomacom.com
Safeguards
ground wires to house with stand-
possible to where
No.6 AWG (13.3mm) copper
CATV SYSTEM INSTALLER
3
Rev. 08/03

Advertisement

Table of Contents
loading

Table of Contents