Table of Contents
Advertisement
EN 8
4.
LC03E MV AA
The function of foam is to give some pressure to the glass to
prevent dust penetrating between glass and LCD panel, and to
ensure even contact between glass and frame.
Foam dimensions are 400x10x3 (long side), 227.6x10x3 (short
side) for the 17" panel and 528x10x3 (long side), 305.6x10x3
(short side) for the 23" panel.
4.8
Mounting the Display Back in Place
When placing the display back in position, it is important to
lower it carefully back into place (establish a firm hold on the
display/ chassis), minimising risk of scratching or damaging the
rear surface of the mirror glass.
Care should be taken not to over tighten the screws, in
order to avoid possible deformation of the glass and image
distortion.
Note:
Before returning the defective LCD panel take care for total
removal of the foam. Use a hair dryer to warm the space
between the foam and the frame so that the foam can be torn
off easily. Residual glue can be removed with some alcohol.
4.9
How to Replace IR Sensor
Access of IR sensor is only possible when decorative frame is
removed. Instructions about replacing the decorative frame are
given in chapter 3 of the Mirror TV Installation Guide.
The IR sensor is removed by removing a securing screw
(M3x4.5) at the front of the aluminium frame. The connection
cable passes through the hole provided in the aluminium
frame, allowing full removal and replacement of the IR sensor.
Take care that screws of correct length (self tapping
D3.5x12.5) are used if fitting a customised frame (they
should not penetrate front of the frame). Normally, the
workshop will not receive the set with customized frames fitted.
Figure 4-8
Mechanical Instructions
F_15730_008.eps
270505
F_15730_009.eps
Figure 4-9
F_15730_010.eps
Figure 4-10
F_15730_011.eps
Figure 4-11
270505
270505
270505
Advertisement
Table of Contents
