Table of Contents
Advertisement
EN 6
4.
LC03E MV AA
4. Mechanical Instructions
Index of this chapter:
4.1 Introduction
4.2 Precautions
4.3 Handling broken mirror glass
4.4 Removing the mirror glass
4.5 Removing Back Cover
4.6 Internal Cabling
4.7 Handling of the Display
4.8 Mounting the Display Back in Place
4.9 How to Replace IR Sensor
Notes:
•
Figures below can deviate slightly from the actual situation,
due to the different set executions.
•
Follow the disassemble instructions in described order.
4.1
Introduction
The Mirror TV product utilizes the existing LCD TV technology
of the Philips 17" and 23" LCD models, and therefore it
provides many of the same features. For familiarity purposes,
the existing Directions For Use (DFU) documentation for the
17" and 23" LCD models can also be used for the Mirror TV.
Some differences may apply, and these differences will be
covered in the enclosed addendum sheet and Installation
Guide (separately available via the ITV organisation).
•
How to replace the decorative frame of the Mirror TV
•
How to wall mount the Mirror TV
4.2
Precautions
Before starting to service:
•
Place a clean dry soft cloth on the table, to avoid damaging
the frame.
•
Only open the mirror TV in a clean environment.
Avoid ingress of dust, particularly on back of mirror.
•
Wear gloves to service the set due to extreme sensitivity to
damages of the mirror and frame.
•
Do not touch the rear side of the glass with bare hands.
•
Due to the special surface used on the rear of the mirror,
surface should only be cleaned with a clean dry cloth (DO
NOT USE any cleaning agents or solvents).
•
MiraVision TVs should be received for repair without
customized frames fitted, as Philips cannot be held liable
for any damage done during service to customers' own
frames. Frames are attached to the TV by screws from
behind.
•
Packaging: Keep one of each box size at each service
centre (standard Outer packaging). Packaging is available
via Euroservice warehouse (see spare parts list).
4.3
Handling broken mirror glass
When a MiraVision TV is sent to service for replacement of a
broken mirror glass, it is important to follow safety guidelines to
avoid any risk of injury:
•
Carefully remove all loose pieces of broken glass.
•
Remove display from frame, following guidelines given
above, watch out for loose glass fragments.
•
Once display is removed, carefully remove the broken
mirror glass.
•
Check for damage to the display. If badly damaged (i.e.
impact on image quality is likely), consider replacement.
•
Insert replacement glass, wearing soft gloves to avoid risk
of damage or marks.
Mechanical Instructions
4.4
Removing the mirror glass
If it becomes necessary to remove the mirror glass (e.g. due to
damage, or breakage), the screws securing the display (and
the display) must be removed (see section Display Removal).
In the case of the hallway models, there are additional securing
screws (M3x4.5) used to hold the upper mirror in place (i.e. not
just the screws that hold the display in place). These must also
be removed.
Figure 4-1 Mirror glass removal
F_15730_013.eps
270505
Advertisement
Table of Contents
