Advertisement
Specifications
IMPORTANT SAFETY INFORMATION
1. Install a 15 amp fuse (not included) inline on the
power supply wire of this item. Using no fuse, or
using an incorrect fuse can cause an electrical fire.
2. Install only according to these instructions.
Improper installation can create hazards.
3. Wear ANSI-approved safety goggles and
heavy-duty work gloves during installation.
4. Do not install while engine is running. Remove
ignition keys from vehicle and set parking brake.
5. When drilling holes, beware of any hidden electrical
lines or cables. Make sure you don't damage or
weaken the structural integrity of the vehicle.
6. Do not use as a replacement for Original
Equipment Manufacturer (OEM) horn(s).
7. Do not install this product in a location that will
exceed 212°F or get submerged in water. It may
stop operating if exposed to any of those conditions.
8. Keep assembly area clean and well lit.
9. Keep bystanders out of the area during installation.
10. Do not expose Horns to rain or wet
conditions. Water entering the Horns will
increase the risk of electric shock.
11. Do not install when tired or when under the
influence of alcohol, drugs or medication.
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Risk of serious personal injury. Turn the vehicle off and disconnect battery before installation.
Note: If unsure about any aspect of installation, have the Horns installed by a qualified mechanic.
1. Prior to installation, turn off the ignition,
shift transmission into park (for automatic
transmissions) or reverse (for manual). Remove
ignition keys from vehicle and allow engine
to cool. Place wheel chocks on both sides of
at least two wheels. Disconnect the vehicle's
battery. Make sure the engine and engine
compartment are cool before installation.
Page 2
Power Requirement
Volume
For technical questions, please call 1-888-866-5797.
12 Volts DC
118 dB
12. Do not install this product yourself unless you
are technically competent to do so. If necessary,
have a qualified technician install the Horns.
13. This product is not a toy. Do not allow
children to play with or near this item.
14. Use as intended only.
15. Inspect before every use; do not use
if parts are loose or damaged.
16. Exposure to noise levels over 85 dB is hazardous
to hearing. Everyone close enough to horn to be
exposed to more than 85 dB must wear ANSI-
approved hearing protection. Do not use Horn
in close proximity to people or animals, as the
decibel level may cause hearing damage.
17. Check and comply with local standards
for noise pollution levels before use.
18. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
19. The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
2. Select a suitable location to mount the Horns.
Location must shelter Horns from incoming rain,
road water, and mud splash from under the
vehicle. Do not mount Horns near hot engine
components or where it may come into direct
contact with hot surfaces or moving parts.
Item 58808
Advertisement
