Resetting To Factory Settings - Bosch Universal switch II Quick Instructions

Start-up
Ensure that you have a Bosch Smart Home
controller and the Bosch Smart Home app and have
successfully configured both. Now start the Bosch
Smart Home app and select "Add new device". Follow
the instructions in the app.

Resetting to factory settings

You can reset the device to its factory settings as
follows:
Remove a battery. Replace the battery while holding
the operating and system button (3) pressed. Hold
the button pressed until the status LED (4) flashes
orange. Now release it briefly and press and hold the
button again until the LED lights green. The device
then restarts. Please note that it can take a few
seconds until the device is ready for operation again.
When resetting to factory settings, the settings
and information are only lost from the device
and not from the Bosch Smart Home controller.
To re-configure the device, first delete it in the
device management section of the Bosch Smart
Home app and then add it again in the usual
pairing process.