Seiko ASTRON 8X82 GPS SOLAR Complete User Manual page 19

4
BASIC OPERATION (HOW TO SET THE TIME/HOW TO RECEIVE GPS SIGNALS, ETC.)
How to adjust the time zone
Go to a place where
1
GPS signals can be
easily received
Move to the outdoors under
an open sky with good
visibility.
Place where GPS signals
can be easily received/Place
where GPS signals cannot
be received P. 16
Continue to press Button B (6 seconds),
2
and then release it when the second hand
moves to the 30-second position.
Although the second hand moves to the
0-second position 3 seconds after pressing
Button B, continue to press it.
When the second hand has reached the
30-second position, reception is started.
The indicator hand points to "4+. "
Press for
6 seconds
While the indicator hand points to "E" or
reception is not started even with operation for
reception.
When the hand points to "E, " charge the watch
by expose to light.
How to charge the watch P . 14
Check whether the watch is able/unable to
receive GPS signals
Check the charging status P . 13
When the hand points to , reset the in-flight
mode ( ).
How to reset in-flight mode ( ) P . 21
When the stopwatch is operating, the reception
function will not be activated.
3
Direct the watch face upward and wait
Please note that it may be difficult to receive GPS
signals while you are in motion.
It takes a maximum of
2 minutes to complete
reception.
It depends on the receiving
conditions.
<
Display during reception (= satellites acquisition
>
status)
The second hand indicates ease of receiving
(= number of GPS satellites from which GPS
signals are received).
The larger the
number of acquired
satellites there are,
,
the easier it is to
receive GPS signals.
Second
hand
position
25-second
Number of
satellites
5 units
Even when the hand
points to 4 units or more,
reception may not be
allowed.
To cancel the reception,
press Button A.
18
ASTRON 8X82 GPS SOLAR
When the second hand points to
4
"Y" or "N," reception is
completed.
The reception result is displayed for 5
seconds.
Then, the hour and minute hands move,
and the time and date are adjusted.
(The time zone is also adjusted to the
local time zone.)
Reception Y: Successful
result (52-second
display position)
Display
0 units
State
2 units watch as it is.
3 units Check that the reception is successful
May
after the watch returns to the time
receive
display mode.
4 units
Check that the reception was
5 units
successful
6 units
Check the time zone setting
During movement of the date, the buttons
and crown cannot be operated.
Manually set DST (Daylight Saving Time).
Set DST (Daylight Saving Time)
Press
Button A P. 19
N: Failed
(38-second
position)
When the reception
Use the
result is displayed as
"N" P . 16
P. 28
P. 17