Table of Contents
Advertisement
Next steps
1.
Close the drive
bays.
2.
Install the power supply
3.
Install the front
bezel.
Installing drive blanks
Prerequisites
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 22. Installing a drive blank
Next steps
1.
Close the drive
bays.
2.
Install the power supply
Installing power supply units
Prerequisites
CAUTION:
Ensure that both the PSUs are of the same type and have the same maximum output power.
The maximum output power (shown in watts) is listed on the power supply unit label.
Steps
Slide the power supply unit into the power supply unit bay until the power supply unit is fully seated and the release latch snaps
into place.
units.
units.
Install the DM5500 in the rack
31
Advertisement
Table of Contents
