Husqvarna 329L Operator's Manual page 10

2. Pull the choke control up.
3. Hold the body of the product on the ground with your
left hand.
CAUTION Do not step on the product.
4. Pull the starter rope handle slowly until you feel
some resistance. When you feel resistance, pull the
starter rope handle 3 times quickly and with force.
WARNING Do not twist the starter rope
around your hand.
5. Push the choke control down.
6. Pull the starter rope handle until the engine starts
and operates .
CAUTION Do not pull the starter rope to
full extension and do not let go of the
starter rope handle. This can cause
damage to the product. Release the
starter rope slowly.
CAUTION Do not engage the throttle
yet.
7. Let the engine become warm during 60 seconds.
8. Engage the throttle fully for 10-15 seconds.
9. To increase the trimmer line, let the trimmer head
touch the ground while the product operates at full
throttle.
Note This is to make sure that the correct load for
the operation is applied.
10
To start a warm engine
1. Push the air purge bulb 10 times.
2. Pull the starter rope handle slowly until you feel
some resistance. When you feel resistance, pull the
starter rope handle 3 times quickly and with force.
Note If the product does not start and operate, refer
To start a cold engine on page 9 .
to
To start the engine when the fuel is too hot
If the product does not start, the fuel can be too hot.
Note Always use new fuel and decrease the operation
time during warm weather.
1. Put the product in a cool area away from open
sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again for 10-15
seconds.
4. Obey the procedure to start a cold engine. Refer to
Technical data on page 18 .
To stop the product
• Push the stop switch to stop the engine.
Note The stop switch automatically goes back to its
initial position.
To operate the grass trimmer
CAUTION Make sure that you slow the
engine to idle speed after each operation. A
long period at full throttle without a load on
the engine can cause damage to the engine.
Note Clean the cover of the trimmer head when you
attach a new trimmer line to prevent vibrations. Examine
other parts of the trimmer head and clean if it is
necessary.
1293 - 001 - 18.09.2019