Adjustment Of The Position Between The Needle And The Shuttle Hook; How To Remove The Sliding Plate - JUKI PLK-J12060 Technical Manual

6-2. Adjustment of the position between the needle and the shuttle hook

6-2-1. How to remove the sliding plate

(1) Turn the power switch OFF.
(2) Open the bobbin access door.
(3) Remove the four screws (No.2) and remove the sliding plate (No.1). In this time, the trimmer link
(No.4) is removed from the driving lever (No.3).
NOTE The trimmer lever (No.4) is fitted with drive lever (No.3) by entering the locate pin witch have
driving lever (No.3) into the trimmer lever (No.4) hole. When remove the trimmer lever (No.4), hold the
trimmer lever (No.4) by hand as in the below drawing and lift the sliding plate (No.1). The trimmer link
(No.4) is removed from the driving lever (No.3) smoothly.
(4) To entering the locate pin witch have driving lever (No.3) into the trimmer lever (No.4) hole smoothly,
aligning the center of the trimmer link (No.4) hole with the reference hole (No.5) when back the sliding
plate (No.1).
<1>: Sliding plate <2>: Screw <3>: Driving lever <4>: Trimmer lever
<5>: Reference hole
<3>
- 17 -
<1>
<5>
<2>
<4>