Ariens 53611500 Instruction Sheet

Instruction Sheet
YT 42-INCH TO 40-INCH BAGGER
CONVERSION KIT
Kit Number: 53611500
For use on: Ariens:
Gravely: 987105, 303
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to unit. Read,
understand, and follow all safety practices in
Owner/Operator Manual before beginning.
Package Contents
Check contents of your kit for the parts listed (figure 1):
Item Description
1 Mower Boot Assembly
2 40-Inch Vane Package
(Gravely Part Number)
3 5/16" x 3/4" Hex Bolt
4 40-Inch Vane
5 5/16" Center Locknut
6 40-Inch Bagger Owner's
Manual
* Comes with 40-inch vane package (item 2).
1
6
© Copyright 2002 • Ariens Company • P.O. Box 157 • Brillion, WI 54110-0157
936029, 032, 033, 035, 315, 319,
320, 330
Qty
Number
1 53602100
1 53504600
035832
8 05970500*
4 03536300*
8 06537000*
1 03672300
3*
4*
5*
2
Figure 1
Install 40-Inch Vanes (Figure 2)
NOTE: Vanes require more power and generate more
noise. The Ariens Company recommends that the bagger
be used without the vanes first. If the bagger
performance is satisfactory, the vanes are not needed.
CAUTION: Vanes MUST be used in pairs. DO
NOT interchange with different or worn vanes
on same blade. Using one of each of a
different type or worn vane will cause blade to
be out of balance. Severe vibration will occur
and may cause damage to the mower that
results in personal injury.
CAUTION: Specific hex bolts and center
locknuts are supplied for the installation of the
vanes. DO NOT substitute. Loose or
Part
damaged hardware may allow vanes to come
off the mower blade causing personal injury.
NOTE: The word "FRONT" is stamped on the vanes; this
side MUST face up.
1. Install the 40-inch vanes (item 4) on mower blades
(item 7) with 5/16" x 3/4" hex bolts (item 3) and
5/16" center locknuts (item 5).
7
3 5/16" x 3/4" Hex
Bolt
4 40-Inch Vane
IE1000
3
4
5 5/16" Center
Locknut
7 Mower Blade
Figure 2
08499800 9/02 Page 1 of 2
5
IDd2000