Yamaha KODIAK 700 Owner's Manual page 108

1. Spark plug gap
Spark plug gap:
0.8–0.9 mm (0.031–0.035 in)
8
To install the spark plug
1. Clean the surface of the spark plug gasket
and its mating surface, and then wipe off any
grime from the spark plug threads.
2. Install the spark plug with the spark plug
wrench, and then tighten it to the specified
torque.
Tightening torque:
Spark plug:
11 N·m (1.1 kgf·m, 8.1 lb·ft)
TIP
If a torque wrench is not available when installing
the spark plug, a good estimate of the correct
torque is 1/4–1/2 turn past finger tight. However,
the spark plug should be tightened to the speci-
fied torque as soon as possible.
3. Install the spark plug cap.
4. Install the storage compartment as shown,
and then install the bolt.
5. Install the panels.
8-19