Note
TV Guide
may also be used to set timer event.
●
Watching > TV Guide > Timer Programming
Timer Programming
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
For recording using
●
Standby.
No other channels can be selected while recording of
●
is in progress.
Recording an encrypted (copy-protected) programme may not be possible.
●
Depending on the network condition, recording function may not work
●
properly in DVB-via-IP.
When the start time comes, the channel will be switched automatically and
●
the video and audio signals will be output. 2 minutes before the start time,
a reminder message appears if you are watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
LED turns to orange in Standby mode when
●
"!" identifies that two or more timer events are overlapped.
●
is given priority over Reminder. As for the overlapped recording events,
the first event starts and finishes as programmed. The next event can then
start.
The recording of
●
the programmed channel a few seconds before the start time.
The recording of
●
in
REW LIVE TV
cancelled.
Recording > Recording current programme > REW LIVE TV
For details of the USB HDD
●
Recording > Technical information
can store up to 15 events.
only works reliably if correct time information is
Timer
Programming, the TV must be either on or in
Timer Programming
Timer Programming
recording. In this case,
- 104 -
Timer Programming
Timer Programming
automatically changes the channel to
is performed even if the TV is
REW LIVE TV
recording is
is set.
USB HDD Rec.