Note - Panasonic TX-40DXF687 Ehelp

Note

TV Guide may also be used to set timer event.
●
Watching > TV Guide > Timer Programming
Timer Programming
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
For recording using
●
Standby.
No other channels can be selected while recording of
●
is in progress.
Recording an encrypted (copy-protected) programme may not be possible.
●
Depending on the network condition, recording function may not work
●
properly in DVB-via-IP.
When the start time comes, the channel will be switched automatically and
●
the video and audio signals will be output. 2 minutes before the start time,
a reminder message appears if you are watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
LED turns to orange in Standby mode when
●
"!" identifies that two or more timer events are overlapped. As for the
●
overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
The recording of
●
the programmed channel a few seconds before the start time.
For details of the USB HDD
●
Recording > Technical information
can store up to 15 events.
only works reliably if correct time information is
Timer Programming, the TV must be either on or in
Timer Programming
- 128 -
Timer Programming
Timer Programming
automatically changes the channel to
is set.