Husqvarna 2-20DT Operator's Manual page 14

1. Turn the 2 adjustment screws at the front to set the
correct height.
2. Turn the 2 adjustment screws at the rear to set the
correct height.
To set correct height of the brush list
seals
The correct height adjustment of the brush lists is 1 mm
from the surface.
14
1. Loosen the screws that holds the brush list.
2. Adjust the height of the brush list.
Abrasive
Speak to your HUSQVARNA dealer for the selection
of correct abrasive for your surface operation. Refer to
Approved abrasive on page 30 .
2037 - 002 - 06.04.2023