Methods Of Stacking Expansion Units - Panasonic KX-NS300 Installation Manual

6.1 Methods of Stacking Expansion Units

6.1 Methods of Stacking Expansion Units
Stacking expansion units with the KX-NS300 allows you to expand the usage of legacy terminals and trunks.
When expansion units are stacked, the KX-NS300 will control communication, as well as all IP terminals on
the site.
Note
For details about connecting an expansion unit to a KX-NS300, refer to the 4.6.1 EXP-M Card
(KX-NS5130) in this manual.
There are 2 ways of stacking Expansion Units with the KX-NS300.
Case 1
Stacking expansion units to a KX-NS300 (not running).
To stack expansion units to a KX-NS300 which is not running currently, refer to "Procedure for Case 1 and
Case 2".
Case 2
Stacking expansion units to a KX-NS300 (running).
To stack expansion units to a KX-NS300 which is already running, refer to "Procedure for Case 1 and Case
2".
Stacking Procedures
The following procedures show how to stack expansion units in each case.
CAUTION
•
When installing or removing the optional service cards, the power switch must be turned off.
•
When installing or removing the optional service cards, do not put pressure on any parts of the mother
board. Doing so may result in damage to the PBX.
Notice
If there is already a expansion unit stacked and connected to a EXP-M card installed in a KX-NS300, you
can skip shutting down the KX-NS300 in the following procedures.
Note
•
For information about starting the KX-NS300 for the first time, refer to "4.13 Starting the KX-NS300".
•
The Expansion Unit will be initialised when started up with a EXP-M card mounted and extension
numbers will be created automatically.
Procedure for Case 1 and Case 2
1.
Follow the procedure below for the expansion unit.
a.
Make sure the power switch is turned off. If the KX-NS300 is running, shutdown the KX-NS300 and
then turn off the power switch.
b.
Connect the LAN cable to EXP-S card.
2.
Follow the procedure below for the KX-NS300.
a.
Make sure the power switch is turned off.
b.
Insert a EXP-M card into the EXP-M card slot.
c.
Connect the LAN cable to EXP-M card.
3.
Follow the procedure below for the KX-NS300 and expansion unit KX-NS320.
a.
Turn the power switch on.
250 Installation Manual