General Procedure; Unpacking The Device; Installing The Device In Hazardous Locations - Siemens RUGGEDCOM RSG908C Installation Manual

Chapter 2
Installing the Device
Section 2.1

General Procedure

The general procedure for installing the device is as follows:
1. Review the relevant certification information for any regulatory requirements.
For more information, refer to
2. Unpack and inspect the device.
For more information, refer to
3. Mount the device.
For more information, refer to
4. Connect the failsafe alarm relay.
For more information, refer to
5. Connect power and ground the device.
For more information, refer to
6. Configure the device.
For more information, refer to
Section 2.2

Unpacking the Device

When unpacking the device, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.
Section 2.3

Installing the Device in Hazardous Locations

The RUGGEDCOM RSG908C is designed to comply with the safety standards for Class I, Division 2, Zone 2
hazardous locations where concentrations of flammable gases, vapors or liquids may be present, as opposed to
normal operating environments.
Special Conditions for Safe Use
Installation and use of the device in a hazardous location must meet the following special conditions for safe use:
• The equipment shall be installed in an enclosure that is considered to be not accessible in normal operation
without the use of a tool providing a degree of protection of not less than IP54 according to IEC 60079-0
6
Section 6.1, "Approvals".
Section 2.2, "Unpacking the
Section 2.4, "Mounting the
Section 2.5, "Connecting the Failsafe Alarm
Section 2.6, "Connecting
Section 3.2, "Configuring the
Device".
Device".
Relay".
Power".
Device".
RUGGEDCOM RSG908C
Installation Guide
General Procedure