Genie ALADDIN CONNECT Quick Setup Manual

Quick Set-up Guide
Aladdin Connect®
Control Wire
Wall Button Wire
Power Pack
Typical Installation shown.
Installations may vary
For a video of this installation, visit www.GenieCompany.com/AladdinConnect/InstallationVideo
Need help or have questions? Contact Aladdin Connect® Customer Service at 1-866-599-4995
Mon-Fri 9am -8pm EST, Sat 10am - 6pm EST.
STEP 1 -
Determine Mounting Location for DCM
Select a location that meets the following criteria:
• Where the DCM can be seen and heard when door is opening
• Within 5ft of a standard 110v AC power outlet
• Within 25ft from either the garage door opener or a wired wall control button.
The DCM is commonly mounted in the following locations:
• Mount above an outlet in the garage - if near the personnel door, the DCM can
be used as a second wall control button or in place of the existing wall button.
• Mount next to opener near ceiling - you can plug it into the same outlet as the
opener and easily wire the DCM to the opener itself.
Once mounting location has been determined, remove the mounting bracket from
the back of DCM, plug in the powercord to the power outlet and connect the plug
to the DCM.
DCM
39386.01577, 03/2023
Recommended Tools
®
Drill & 3/32 Bit
DCM
Small Common
(Door Control Module)
Screwdriver
Photocell wire
5/16 Wrench or
Nut Driver
Phillips Head
Screwdriver
Wire Cutters/
Hardware Bag
Strippers
Hammer
Wire Spool
Scan for the
Aladdin Connect®
installation video
STEP 2 -
Check Wi-Fi coverage
Before beginning, please verify the Wi-Fi signal in the garage.
• Connect smartphone to the home Wi-Fi and walk into the garage.
• Place phone where the DCM will be mounted.
• The Wi-Fi signal strength at that location must be at least two bars.
If there are not at least two bars, try these steps to improve signal strength:
• Make sure that the Wi-Fi router is out in the open (not behind large electronics or
in a cabinet).
• Move the Wi-Fi router closer to the garage.
• Purchase a Wi-Fi extender, available at most electronics stores.
Device Wi-Fi signal strength indicator
IMPORTANT SAFETY
Included Components
INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF SEVERE INJURY
OR DEATH, READ AND FOLLOW ALL
INSTRUCTIONS.
1. NEVER let children operate or play with the
DPS
door controls.
(Door Position Sensor)
2. Keep remote away from children.
3. Locate the wall control button: A) Within sight
of door. B) At a minimum height of 5 feet, so
small children cannot reach it.
4. Install the entrapment WARNING label next
to the wall button or console, in a prominent
location.
5. NO ONE SHOULD CROSS THE PATH OF THE
MOVING DOOR.
Power Pack
6. NEVER GO UNDER A STOPPED, PARTIALLY
OPEN DOOR.
Insulated
7. The Aladdin Connect® operating system is
Staple x30
designed for unattended operation. The door
could move unexpectedly.
8. DO NOT install Aladdin Connect® on garage
Scan here for additional
door openers manufactured prior to 1993
without photocell non-contact safety sensors.
Aladdin Connect®
9. DO NOT install on one-piece doors
information
10. 10. Install DCM in a location where it can be seen Install DCM in a location where it can be seen
and heard while standing in the door opening and heard while standing in the door opening
with the door in the open position. with the door in the open position.
SAVE THESE INSTRUCTIONS
WARNING
UNPLUG GARAGE DOOR OPENER PRIOR TO
INSTALLING Aladdin Connect®
Door may operate unexpectedly.
STEP 3 -
Download the app.
1. Scan the QR code below or visit the devices app store to start the setup of the Aladdin Connect® device.
Search the app store for Aladdin Connect
2. Follow the instructions in the app to create an account and set up the device and Wi-Fi.
Scan for
iOS app
Apple and the Apple logo are trademarks
of Apple Inc., registered in the U.S. and
other countries. App Store is a service
mark of Apple Inc.
CONSIGNES DE SÉCURITÉ
IMPORTANTES
AVERTISSEMENT
POUR RÉDUIRE LE RISQUE DE BLESSURES
GRAVES VOIRE MORTELLES, LIRE ET
COMPRENDRE TOUTES LES INSTRUCTIONS.
1. NE JAMAIS laisser les enfants utiliser ou jouer avec les
commandes de l'ouvre-porte.
2. Tenir les télécommandes hors de la portée des
enfants.
3. Localiser le bouton de la console murale : A) En vue
de la porte. B) À une hauteur minimale de 1,5 m afin
que les jeunes enfants ne puissent pas l'atteindre.
4. Placer l'étiquette d'AVERTISSEMENT en cas de
coinçage à proximité du bouton mural ou de la
console murale de manière à ce qu'elle soit bien en
évidence.
5. NE JAMAIS PASSER SOUS LA PORTE EN MOUVEMENT.
6. NE JAMAIS PASSER SOUS UNE PORTE À L'ARRÊT
PARTIELLEMENT OUVERTE.
7. Le système d'exploitation Aladdin Connect® a été
conçu pour fonctionner sans surveillance. La porte
peut se déplacer de façon inattendue.
8. NE PAS installer Aladdin Connect® sur les ouvre-
portes de garage fabriqués avant 1993, sans capteurs
de sécurité photoélectrique sans contact.
9. NE PAS installer sur les portes d'une seule pièce.
10. Installez DCM dans un endroit où il peut être vu et
entendu tout en se tenant dans l' o uverture de la porte
avec la porte en position ouverte.
CONSERVER CES INSTRUCTIONS
AVERTISSEMENT
DÉBRANCHER L'OUVRE-PORTE DE GARAGE AVANT
D'INSTALLER Aladdin Connect®
La porte peut fonctionner de façon inattendue.
Scan for
Android app