Adding A Dog To The Alpha Navigator Using Wireless Pairing; Sharing A Dog Wirelessly; Adding A Dog Using The Track And Control Codes; Vhf Radio Information - Garmin Alpha 300 Owner's Manual

Adding a Dog to the Alpha Navigator Using Wireless Pairing

To pair wirelessly, the dog collar device must be within range of the Alpha navigator.
1 Hold the power button on the dog collar device until the device emits two series of beeps (about 2 seconds),
and then release the power button.
The status LED flashes blue. The dog collar device is now ready to be paired with a navigator.
2 On the navigator, select Dog List > Add Dog.
3 Select Pair Collar, and follow the on-screen instructions.
4 After successfully adding the dog collar device, enter the name of the dog, and select
5 Select a beacon color for this dog collar device, and select

Sharing a Dog Wirelessly

Before you can share data wirelessly over ANT+, you must bring your Alpha handheld device within 3 m (10 ft.)
of the other handheld device.
1 Select Dog List.
2 Select the dog to share.
3 Select > Share Wirelessly.
4 Select an option:
• To allow the other person to track your dog's location with the map and dog tracking compass, select
Track Only.
• To allow the other person to track your dog and correct your dog's behavior, select Track and Control.
To successfully share the dog collar device, the other handheld device must be receiving the device
information (Adding a Dog to the Alpha Navigator Using Wireless Pairing,

Adding a Dog Using the Track and Control Codes

NOTE: This feature varies based on dog collar device type and feature availability in your area.
Before you can add a dog using the track and control codes, the dog owner must find the track and control
codes (Finding the Dog ID and Track and Control Codes,
You can use track and control codes to authorize a handheld device to interact with your dog collar device. If
you are not near the dog you want to add or you cannot put the collar into pairing mode, you can add the dog
using the track and control codes.
1 Select Dog List > Add Dog.
2 Select Enter Track or Control Code.
3 Enter the track or control code for the collar, and select
The dog's track code allows you to track the dog. The dog's control code allows you to both track and train
the dog.
4 Enter the name of the dog, and select
Finding the Dog ID and Track and Control Codes
You can share a dog's track code so another person can track your dog. Also, you can share a dog's control
code so another person can track and train your dog.
1 Select Dog List.
2 Select a dog.
The track code and the control code are displayed under the dog's name.

VHF Radio Information

This product may be used only on specific radio frequencies, which vary depending on the country of use.
The navigator and dog collar device allow the user to install a different antenna. Changing the antenna can
result in improved radio performance and higher radiated power. You must not use the device with a third party
antenna or an antenna not approved by Garmin
performance and radio frequency of this product, lawful accessories, and power limits for countries.
Dog Collar Device Setup
.
page 7) and tell them to you.
.
.
® . Go to www.garmin.com/tracking-legal
.
page 7).
for details about the
7