Download Print this page

Operating Temperature - Carrier 40MHHA Owner's Manual

Advertisement

40MHHA: Owner's Manual
Remote Control Operation - Quick Start
NOTE: When transmitting a command from the remote control to
the unit, be sure to point the control toward the right side of
the unit. The unit confirms receipt of a command by
sounding an audible beep.
1. Turn the unit on by pushing ON/OFF.
NOTE: If there is a preference for °C rather than °F (default), press
+
-
and hold the
and
for approximately 3 seconds.
2. Select the desired mode by pushing MODE.
AUTO
COOL
Fig. 9 —Modes
3. Select the temperature set point by pointing the control toward the unit
and pressing the increase/decrease temperature set point buttons until
the desired temperature appears on screen.
4. Press FAN to select the desired fan speed.
NOTE: If the unit is operating in DRY or AUTO mode, the fan speed
will be automatically set and cannot be adjusted.
Set the airflow direction. When the unit is turned on, the Up-Down airflow
louvers default to the cooling or heating position. The user can adjust the
horizontal Up-Down airflow louver position by pushing DIRECT or have
continuous louver movement by pressing SWING.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
temperature set point buttons together
DRY
HEAT

OPERATING TEMPERATURE

When your air conditioner is used outside of the following temperature
ranges, certain safety protection features may activate and cause the unit
to disable.
Table 1 — Inverter Split Type
Room
Temperature
FAN
Outdoor
low temp.cooling
Temperature
NOTE: FOR OUTDOOR UNITS WITH BASEPAN HEATER OR
CRANKCASE HEATER.
When the outside temperature is below 32°F (0°C), we strongly
recommend maintaining power on the unit to ensure smooth ongoing
performance.
To optimize unit performance, perform the following:
• Keep doors and windows closed
• Limit energy usage by using TIMER ON and TIMER OFF
functions.
• Do not block air inlets or outlets.
• Regularly inspect and clean air filters.
8
COOL MODE
HEAT MODE
62°F - 90°F
32°F - 86°F
(17°C - 32°C)
(0°C - 30°C)
32°F - 122°F
(0°C - 50°C)
5°F - 122°F
(-15°C - 50°C)
For models with
5°F - 75°F
(-15°C - 24°C)
systems.)
32°F - 126°F
(0°C - 52°C)
(For special
tropical models)
DRY MODE
50°F - 90°F
(10°C -32°C)
32°F - 122°F
(0°C - 50°C)
32°F - 126°F
(0°C - 52°C)
(For special
tropical models)

Advertisement

loading