Philips 32PFL3904H/12 Service Manual page 35

6.5.1 SSB identification
Whenever ordering a new SSB, it should ne noted that the
correct ordering number (12nc) of a SSB is located on a sticker
on the SSB. The format is <12nc SSB><serial number>. The
ordering number of a "Service" SSB is the same as the ordering
number of an initial "factory" SSB.
6.6 Total Overview SAM modes
Table 6-5 SAM mode overview
Main Menu Sub-menu 1
Hardware Information A. SW VERSION
B. Stand-by processor version e.g. "STDBY_84.69.0.0"
C. Production code
Operation hours
Error
Reset error buffer
Alignment Tuner AGC
White point
Dealer options Picture mute
Virgin mode
E-sticker
Auto store mode
Alignments
Sub-menu 2 Sub-menu 3
e.g. "Q5431_0.26.10.0"
e.g. "See type plate"
Colour temperature Normal
Warn
Cool
White point red
White point green
White point blue
Red black level offset
Green black level offset
Off/On
Off/On
Off/On
None
PDC/VPS
TXT page
PDC/VPS/TXT
Q543.1E LA
Figure 6-1 SSB identification
Description
Display TV & Stand-by SW version and CTN serial
number.
Displays the accumulated total of operation hours.TV
switched "on/off" & every 0.5 hours is increase one
Displayed the most recent error.
Clears all content in the error buffer.
RF-AGC Take over point adjustment (AGC default
value is 64)
3 difference modes of colour temperature can be se-
lected
LCD White Point Alignment. For values,
see Table 6-1.
Select Picture mute On/Off. Picture is muted / not
muted in case no input signal is detected at input con-
nectors.
Select Virgin mode On/Off. TV starts up / does not
start up (once) with a language selection menu after
the mains switch is turned "on" for the first time (virgin
mode)
Select E-sticker On/Off (USP's on-screen)
Autostore mode disabled (not in installation menu)
Autostore mode via ATS (PDC/VPS) enabled
Autostore mode via ACI enabled
Autostore mode via ACI or ATS enabled
6. EN 35
18310_221_090318.eps
090319
2009-Nov-20