Setup; Installing The Handle - Toro Recycler 22187TE Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Handle

Parts needed for this procedure:
1 Handle
2 Bolt (5/16 x 1-1/4 inches)
4 Washer
2
Thin locknut (5/16 inch)
2 Bolt (5/16 x 1-1/2 inches)
2 Locknut (5/16 inch)
1 Bag support rod
2 Cap locknut
1 Cable tie
Procedure
1. Mount the handle to the outside of the lawn mower
housing (using the bottom hole) with 2 bolts (5/16
Description
Handle
Bolt (5/16 x 1-1/4 inches)
Washer
Thin locknut (5/16 inch)
Bolt (5/16 x 1-1/2 inches)
Locknut (5/16 inch)
Bag support rod
Cap locknut
Cable tie
No parts required
Self-tapping screw
Fuel tank
Discharge tunnel plug
No parts required
Qty.
1
2
4
2
2 Install the handle.
2
1
2
1
–
Install the starter rope.
2
Install the fuel tank.
1
1 Install the discharge tunnel plug.
–
Fill the crankcase with oil.
x 1-1/4 inches), washers, and thin locknuts (5/16
inch) (Figure 3).
1. Handle latch
2. Bag support rod
3. Cap locknut (2)
2. Secure the handle latches to the handle with 2 bolts
(5/16 x 1-1/2 inches), washers, and locknuts (5/16
inch) (Figure 3).
Note: You can adjust the handle height for
comfortable operation. Stand behind the handle to
determine the height. To adjust the handle height,
position the cap screws and the locknuts that secure
8
Use
Figure 3
4. Handle
5. Bolt (5/16 x 1-1/2 inches)
6. Bolt (5/16 x 1-1/4 inches)