Toro 95-3350 Installation Instructions

Ce update kit for aerator 686 and 687

Download this manual

CE Update Kit

Aerator 686 and 687

Model No. 95-3350

Safety

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area

of potential danger. Replace any decal that is damaged or missing.

686 Aerator Only

1. Warning—read the

Operator's Manual.

1. Stored energy hazard—read the Operator's Manual.

8111 Lyndale Avenue South

Bloomington, MN 55420

95-3357

2. High pressure fluid,

injection into body

hazard—seek medical

attention.

93-6696

decal95-3357

decal93-6696

Form No. 3364-365 Rev C

Installation Instructions

*3364-365*

Original Instructions (EN)

Printed in the USA

Page 1 Form No. 3364-365 Rev C CE Update Kit Aerator 686 and 687 Model No. 95-3350 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing.
Page 2 Installation Relocating the Manual Tube Park the machine on a level surface, lower the cutting units, engage the parking brake, shut off the engine, and remove the key. Note: If the manual tube is mounted to the rear of the main frame member, remove it and install it on the front of the aerator so that you can access the manual after the guards are installed.
Page 3 Assembly (686 Aerator Only) Position the guard assembly onto the main Obtain a Jack Kit (Toro Part No. 106-9660) from frame arms until the 4 U-clamps straddle the an authorized Toro distributor. arms and the guard openings are centered over...
Page 4 Installing the CE Decals For the 686 Aerator: Place the 93-6696 decal on the left and right Note: Thoroughly clean the area where you are sides of the lift arms, directly below where the going to apply the decal and let it dry before placing cylinder attaches as shown in Figure the decal.