Connecting A Vcr And Cable Box - Magnavox 51MP392H User Manual

Connecting Accessory Devices to Your TV
P resented here is a connection example
involving a VCR and cable box.
Refer to the VCR's directions-for-use manual
for further information on connections.
To make the connections in this example, you
will need:
• one, two-way signal splitter
• two coaxial cables (75Ω)
• one cable for a video connection (standard
RCA connector)
• two cables for audio connections (standard
RCA connectors) (only one cable is needed
for connection to a nonstereo VCR).
NOTE: The cables are not supplied with your
TV. You should be able to buy them at most
stores that sell electronics. Or you can call
our Customer Care Center at
1-800-531-0039.
1
Connect a cable TV signal to a two-
way signal splitter.
2
Connect one of the two-way signal
splitter outputs to the INPUT on the
cable box.
3
Connect the other two-way signal
splitter output to the ANTENNA IN
75Ω on the rear of the TV.
4
Connect from the cable box OUTPUT
jack to the ANT IN jack on the rear of
the VCR.
5
Connect the VIDEO OUT jack on
the VCR to the INPUT-AV 1 VIDEO
jack on the rear of the TV.
6
Connect the AUDIO OUT R(ight)
and L(eft) jacks on the VCR to
INPUT-AV 1 AUDIO jacks on the rear
of the TV.
NOTE: If your VCR is mono (nonstereo),
you will connect only one audio cable.
Connect only the left audio cable,
which usually has a white connector.
7
Press the AV button on the remote
control as many times as necessary
to select the AV1 source.
8
Turn the VCR on and push PLAY to
view a videotape.
C
ONNECTING A
3
Rear of VCR*
* (Example: Philips
VCR model
VR674CAT)
AV1
VCR C
AND ABLE
5
6
ANTENNA IN 75Ω INPUT-AV 1 OUTPUT
Y
VIDEO
Pb
L
AUDIO AUDIO
Pr
R
Two-way
Signal
Splitter
1
• A cable box will not send stereo sound to the
7
ANTENNA IN 75Ω jack on the TV.
However, if your cable box has A/V outputs,
those might be able to supply video and
stereo audio to A/V jacks on either the VCR
or the TV. Check with your cable company.
• To simplify making connections, the plugs
on audio and video cables are often color
coded. The jacks on your TV are likewise
color coded to match the plugs.
The coding is as follows:
—Yellow for video (composite)
—Red for the right audio channel
—White for the left audio channel
NOTE: If your VCR is mono (nonstereo),
you will connect only one audio cable. You
must ensure that the TV is set to MONO for
the signal source to which you've connected
the VCR (INPUT-AV 2, INPUT-AV 1, or the
side panel inputs [AV3]). Otherwise, you will
receive sound from only one of the TV's
speakers. See page 27.
10
B
OX
Rear of TV
HD INPUT-AV 4
G/Y
R/Pr
INPUT-AV 2
B/Pb
VIDEO
S-VIDEO
L
V
L L
SYNC
AUDIO
H
R
R
4
AUDIO
L
IN
OUT
R
VIDEO
IN
OUT CH3 CH4
OUTPUT
INPUT
2
Coaxial Cable Lead-in from
Cable TV Company
or VHF/UHF Antenna
H H
ELPFUL INT
ANT
IN
OUT
Rear of Cable Box