Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Miele DA 424 V
Summary of Contents for Miele DA 424 V
- Page 1 Operating and installation instructions Cooker hood DA 424 V with extended canopy en - AU, NZ To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed or used for the first time.
-
Page 2: Table Of Contents
Contents Caring for the environment ......... . 3 Warning and Safety instructions . -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 4: Warning And Safety Instructions
Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property. - Page 5 Technical safety Installation, maintenance and repairs may only be carried out by a Before installation, check the cooker Miele authorised person in accordance hood for visible signs of damage. with current national and local safety Under no circumstances should you regulations.
- Page 6 These models may only be combined with a Miele external motor. This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk...
- Page 7 The Miele DSM 400 control module or by other technical measures, such offers the possibility of combining other as ensuring that the cooker hood can...
- Page 8 Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé...
- Page 9 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... - Page 11 Guide to the appliance a Cover plate k Touch control for the grease filters b Telescopic tower The indicator lamp for the grease filter touch control lights up when the grease c Canopy filters need to be cleaned. The canopy is not designed to be This control is used to reset the used as a shelf.
-
Page 12: Modes Of Operation
Modes of operation The cooker hood works with . . . air extraction: The air is drawn in, cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap, which is closed when the cooker hood is switched off. No exchange of room air and outside air can take place. -
Page 13: Use
To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off touch control. ^ To set this option, both the fan and The fan runs at power level "II". -
Page 14: Run-On Option
Run-on option The indicator lamps for fan power levels I and IV will flash if the automatic It is advisable to run the fan for a few switch-off of the Intensive setting is not minutes after cooking has finished to activated. -
Page 15: To Switch The Lighting On
To switch the lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting touch ^ Pressing the On/Off touch control will control to switch on the hob lighting. - Page 16 Reading the filter operating hours Altering the grease filter operating counter hours counter To check the percentage of time set You can set the operating hours already used: counter to suit the type of cooking you – Select a short time if you roast or fry a lot.
-
Page 17: Adjusting The Height Of The Canopy
Adjusting the height of the canopy The height adjustment feature on the canopy can be used to – The – / + control lamps show the time which has been set: – adapt the height of the hood to suit 1st lamp from the left = 20 hours the installation conditions. -
Page 18: Cleaning And Care
A range of Miele branded cleaning and cleaning agents. conditioning agents are available to These will damage the surface order through your Miele Dealer / material. -
Page 19: Grease Filters
Cleaning and care Grease filters Controls Re-usable metal filters are fitted which The controls may suffer remove solid particles (oil, dust, etc.) discolouration or damage if soiling is from the kitchen vapours, preventing left on them for too long. Remove soiling of the cooker hood. - Page 20 65°C programme, ensuring the spray ^ After replacing the grease filters, arm is not obstructed. If a Miele press the grease filter touch control dishwasher is being used, select the for approximately 3 seconds to re-set Sensor wash programme.
-
Page 21: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that – it is switched off at the isolator, or – the screw-out fuse is removed (in countries where this is applicable). -
Page 22: Appliance Dimensions
– 650 mm above gas hobs and cookers. If this cooker hood is installed above a Miele Wok CS 1028 CombiSet (Ceiling fixing viewed from above) appliance, a minimum safety distance of 760 mm must be 1) Alternative positions for feeding... -
Page 23: Installation
Installation Before installation, it is important to read the information given on the 2 screws M4 x 8 mm following pages as well as the for securing the tower. "Appliance dimensions" and the "Warning and Safety instructions" at the beginning of this booklet. This is particularly crucial when 4 spacers to use in the event of an using the cooker hood at the same... -
Page 24: Extending Or Limiting The Adjustment Range
Installation Extending or limiting the adjustment Ensure that the tower is held range securely while carrying out the The height range for the appliance can following steps. Danger of inury. be extended or limited by moving the limit switch. It may be necessary to do this if –... - Page 25 Installation dai2262 ^ Secure the limit switch opposite the guide on the telescopic tower (see illustration). ^ Raise and lower the canopy and dai2260 check that the limit switch is working. ^ Loosen the top limit switch. ^ Remove the safety screw and push the tower downwards.
-
Page 26: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations. -
Page 27: Operation With Dsm 400 Control Module
Operation with DSM 400 control module The Miele DSM 400 control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g. -
Page 28: Connection To A Light Switch
Operation with DSM 400 control module Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it (depending on model) via a light switch in the house. Installation The control module is fitted in the tower after the cover plate has been unscrewed from the ceiling. -
Page 29: Connection For Air Extraction
Connection for air extraction – Where ducting is horizontal, it must Important: To avoid the danger be laid to slope away at at least 1 cm of toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as... -
Page 30: Condensate Trap
Connection for air extraction Important: If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. -
Page 31: After Sales Service
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. -
Page 32: Technical Data
Technical data Total connected load..455 W Fan motor ....200 W Variable height motor ..175 W Hob lighting . - Page 36 Alteration rights reserved / 4309 M.-Nr. 07 261 320 / 03...