Table of Contents
Advertisement
Remote Control - Effective Range
To ensure proper function of the remote control
follow the steps below:
1. The remote control must be held at an angle
within 30° perpendicular to the projector's IR
remote control sensor(s).
2. The distance between the remote control and
the sensor(s) should not exceed 8 m (26 ft.)
NOTE: Refer to the illustration for the location
of the infrared (IR) remote control
sensor(s).
Remote Control - Replacing the Batteries
1. Place the remote control facedown and remove the battery tray from the bottom
of the remote control by pressing the side tab and pulling it out.
2. Remove any existing battery (if necessary) and install one CR2032 battery.
NOTE: Observe the battery's polarities as indicated.
3. Replace the battery tray by aligning it with the base and pushing it back into
position.
NOTE:
• Avoid leaving the remote control and batteries in excessive heat or a humid
environment.
• Replace only with the same or equivalent type recommended by the
battery manufacturer.
• If the battery is drained or if you will not be using the remote control for
an extended period of time, remove the battery to avoid damage to the
remote control.
• Dispose of used batteries according to the manufacturer's instructions and
local environment regulations for your region.
12
IR Receiver
IR Receiver
Advertisement
Table of Contents
