Cleaning; Troubleshooting - Bosch MGM8832 IN Series Instruction Manual

en

Cleaning

Cleaning
W Risk of electric shock!
Never immerse the main unit in water or
any other liquid or pour any liquid over it.
Never hold under running water and do not
clean in the dishwasher.
To keep your Bosch mixer grinder sparkling
clean, just follow these steps.
1. First remove the mains plug from the
electrical socket.
2. Clean the main unit using a damp/wet
cloth. Do not use abrasive cleaning
agents.
3. Hold the jar under running water for a
minute after each use to remove the
residue.
4. Please remove active flow breaker while
cleaning the jar. For instructions how to
remove it, please refer to X "How to fit/
remove active flow breaker" see page 6.

Troubleshooting

Trouble
Mixer grinder does not
switch on
Time taken for mixing/
blending is very long
Unit overheating
The coupler and/or some
other parts are removed
during removing the blade.
8
5. Remove the jars after each use and
6. Dry the parts thoroughly with a clean
7. Always keep/store the jars upside down.
8. We recommend you clean your Bosch
9. Do not immerse the main unit in water
10. Regularly clean the jars and gaskets
11. After every use of the Mixer Grinder,
Reason
No power supply.
Overloading with
ingredients.
Overload protection
mechanism is activated.
Other than above
mentioned.
Loose blade or wrong
blade selection.
Overloading of mixer.
External heat source.
Uneven surface that
blocks air vents.
Overloading with
ingredients.
This is normal and may
happen during changing
the blade.
wash in soapy water. Then rinse with
clean water.
soft cloth.
mixer grinder immediately after use for
easier removal of residue.
or any other liquid or pour liquid over it.
after each use for proper hygiene and
performance of the Mixer Grinder.
pour small amounts of hot water into
the jars to remove the leftover or sticky
substances.
Check
Check mains supply.
Remove some ingredients, process
smaller quantities.
Press the red reset button on the
bottom of the mixer grinder.
Call Bosch service centre.
Check blade and choose blade as
per grinding requirements. Tighten
properly with spatula/spanner.
Remove some ingredients, process
smaller quantities.
Check and remove any heat
source, if nearby.
Place the mixer on a level surface.
Remove some of the ingredients
and add in small quantities.
X "Blade changing procedure" see
page 9.