Unpacking; General Safety Information & Warnings - Hoover 7128-02 Instructions Manual

UNPACKING

Carefully remove unit from carton.
Refer to the Supplied Parts list on page 2 to verify that all parts are present.
GENERAL SAFETY INFORMATION & WARNINGS
1. Electric Service supply must be 120V 60Hz.
2. Follow all local safety and electrical codes as well as NEC (National Electrical Code) and
OSHA (Occupational Safety and Health Act).
3. This unit must be properly grounded.
4. Always disconnect the power supply prior to servicing the fan, motor or junction box.
5. Do not bend or kink the power wires.
6. Do not install where the room air temperature will exceed 40ºC (104ºF).
7. This ventilation fan is approved for use over a bathtub or shower when installed in a
GFCI protected circuit. Do not use fans over a bathtub or shower that are not approved
for that application and marked accordingly.
8. Do not use to exhaust hazardous or explosive vapors.
9. Do not install in a cooking area.
10. Do not install this fan vertically in a wall.
11. Use this unit in the manner intended by the manufacturer. If you have any questions
please call the manufacturer (customer service number located on last page).
12. Installation work must be carried out by a qualified person(s) in accordance to all local
and safety codes including the rules for fire-rated construction.
13. Sufficient air supply is required for proper combustion and the exhaustion of gases
through the chimney (flue) of fuel burning equipment to prevent back-drafting. See
the standards of NFPA (National Fire Protection Association) and ASHRAE (American
Society for Heating Refrigeration and Air Conditioning Engineers) and the local building
code authorities.
14. Exercise care to not damage existing wiring when cutting or drilling into walls or ceilings.
15. Fans should always be vented to the exterior and in compliance with local codes.
16. Do not use this fan with any solid state control device.
17. Prior to service or cleaning this unit, shut off power supply at the panel and lock to
prevent the power from being turned on. If the panel cannot be locked, clearly mark
the panel with a warning tag to prevent the power from being turned on.
18. Do not install in a ceiling with insulation greater than R42.
19. Duct work should be installed in a straight line with minimal bends.
20. Duct work size must be a minimum of the discharge and should not be reduced.
Reducing the duct size can increase fan noise.
www.homewerksww.com
Instructions
5