Adjustment - Sharp CD-E700H Service Manual

CD-E700H
CD MECHANISM SECTION
Perform steps 1, 2, 3, 10, 11, 12 and 13 of the disassembly
method to remove the CD mechanism.
How to remove the loading motor
(See Fig. 10-1)
1. Bend the hooks (A1) x 5 pcs., to remove the loading motor.
How to remove the pickup unit (See Fig. 10-2)
1. Remove the stop washer (B1) x 1 pc., to remove the gear
(B2) x 1 pc.
2. Remove the screws (B3) x 2 pcs., to remove the shaft
(B4) x 1 pc.
3. Remove the pickup.
Note
After removing the connector for the optical pickup from the
connector wrap the conductive aluminium foil around the front
end of connector so as to protect the optical pickup from
electrostatic damage.
MECHANISM SECTION
• • • • • Driving Force Check
Torque Meter
Play: TW-2111
• • • • • Torque Check
Torque Meter
Play: TW-2111 30 to 80 g.cm
Fast forward: TW-2231 —
Rewind: TW-2231 —

ADJUSTMENT

Specified Value
Tape 1: Over 80 g
Tape 2: Over 80 g
Specified Value
Tape 1 Tape 2
30 to 80 g.cm
70 to 180 g.cm
70 to 180 g.cm
Loading
Tray
(B3)x2
ø2.6x6mm
Shaft
(B4)x1
• • • • • Tape Speed
Test Tape
Normal MTT-111
speed
TAPE MECHANISM
– 10 –
Loading
Motor
Figure 10-1
Stop Washer
(B1)x1
CD Mechanism
Gear
(B2)x1
Figure 10-2
Specified
Adjusting
Value
Point
3,000 ± 30 Hz
Variable
Resistor in
motor.
Tape
Motor
Variable Resistor in motor
Figure 10-3
Loading
Motor PWB
(A1)x5
Pickup
Unit
Instrument
Connection
Speaker
Terminal
(Load
resistance:
6 ohms)