National Instruments M Series Installation Manual page 2

INSTALLATION GUIDE
Externally Powered USB M Series Panel Mounting Kit
The externally powered USB M Series panel mounting kit (part number 780214-01) is an accessory you
can use to mount NI USB-622x/625x/628x devices to a panel.
Complete the following steps to install the panel mounting kit on your NI USB-62xx device.
1. Remove the rubber feet from the bottom of the USB-62xx device.
2. Fasten the wall mounts to the USB-62xx device using a #2 Phillips screwdriver and four
M4 × 10 panhead screws, included in the panel mounting kit. Verify that the narrow ends of the
panel mounting screw keyholes are pointing up. Tighten the screws to a torque of 1.29 N · m
(11.5 lb · in.). Figure 1 shows a wall mount being attached to a USB-62xx device.
1 USB-62 xx Device
2 Wall Mount
3. Use four M4 or #8 screws to attach the wall mounts to the panel. Tighten the screws, leaving room
to easily remove the device from the panel.
L
T S
N A
T I O E N
U M
N A
T R
I N S
Figure 1. Attaching the Wall Mounts to a USB-62 xx Device
1
3 M4 x 10 Panhead Screw
4 Panel Mounting Screw Keyhole
2
3
4