Problem Solving - Midland G11 PRO Instruction Manual

Problem solving

Problem
The radio doesn't switch
on
The radio switches off
shortly after it has been
switched on
The battery pack does
not recharge
The radio switches on
but is unable to receive
signals
Noise is always present in
reception mode
It is not possible to
communicate with other
parties
Midland G11 PRO instruction guide
Possible Cause
The battery pack is di-
scharged and/or has not
been installed correctly.
Discharged battery pack.
The battery-charger has
not been connected or
installed correctly.
The site of installation is
too shielded.
The volume is too low
Incorrect CTCSS or
DCS
The Monitor function is
enabled.
An incorrect radio chan-
nel has been selected.
The radio is installed in a
shielded area or is too far
from the party you are
communicating with
Incorrect CTCSS or
DCS
Solution
Verify that the battery
pack is charged and that
it has been correctly
installed.
Recharge the battery
pack.
Inspect the connections
of the battery-charger
and the installation of the
batteries.
Move to an another area.
Adjust the volume level.
Check that the CTCSS
tone or DCS code
corresponds to the one
set by the parties you are
communicating with.
Disable the Monitor
function.
Select the same radio
channel used by the
parties you are commu-
nicating with.
Move to another area.
Check that the CTCSS
tone or DCS code
corresponds to the one
set by the parties you are
communicating with.
| 11