Dishwasher Feedback Section; Canceling A Cycle; Changing A Cycle After Dishwasher Is Started - Kenmore Ultra Wash 665.1454 Series Use & Care Manual

Table of Contents

Available languages

Delay Hours

Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak

hours when possible. Delay displays how many hours before the cycle will begin.

To delay the start:

1. Select a wash cycle and options.

2. Press the DELAY HOURS button to choose the number of hours to be delayed.

3. Press START/RESUME to begin the delay countdown.

NOTE: Anytime the door is opened for more than a few seconds (such as, to add a dish), you must press the Start/Resume

button again and close the door within 4 seconds to resume the delay countdown.

Cycle Indicators and Time Display

Selecting Cycles and Options

1. To repeat the same cycle and options used on the previous cycle, press START/RESUME once to show which selections you

used. Press START/RESUME again and close the door within 4 seconds to run the cycle. If the door is not closed in time, the

dishwasher will beep several times and will not start.

2. To start a new cycle, select the desired cycle and options, then press START/RESUME and close the door within 4 seconds to

run the cycle. If the door is not closed in time, the dishwasher will beep several times and will not start. Not all options are

available for every cycle. If an invalid option is selected for a given cycle, the lights will flash.

Turning On/Off the Sound

Press and hold HIGH TEMP for 3 seconds to toggle sound on and off. The sound will not be deactivated for cycle interruption.

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.

2. To cancel selections and/or drain, press the CANCEL/DRAIN button. The drain will not begin until the door is closed.

3. Close the door. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain

completely. The Cancel/Drain light will turn off after 2 minutes.

You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.

1. See steps in the previous "Canceling a Cycle" section for canceling the current cycle.

2. Check that the detergent dispenser cover is still closed. If the cover is open, you will need to refill the detergent dispenser

before restarting your new cycle.

3. Select a new cycle and options.

4. Press START/RESUME and close the door within 4 seconds.