Sony SRG-120DU Technical Manual page 37

Execution Command List (4/4)
Command Set Command
Pan-tiltDrive Up
4)
Down
Left
Right
UpLeft
UpRight
DownLeft
DownRight
Stop
AbsolutePosition
RelativePosition
Home
Reset
Pan-tiltLimitSet LimitSet
LimitClear
When the power is turned off using VISCA over USB, it is not possible to turn on the power of this unit using the power ON command
1)
of VISCA over USB. In this case, turn on the power using the infrared remote commander.
After the ACK for One Push WB Trigger is issued, "Not Executable" is returned to all commands until the operation is completed.
2)
Bright is set only in the mode of Full Auto or Shutter Priority.
3)
Does not operate when the menu is displayed.
4)
Do not turn off the power of this unit before the response to the command is returned.
5)
In case that the power is turned off, the image may not be output correctly. In such case, try to execute the operation using the different
setting value once, and then execute the operation using the correct setting value.
When CAM_LowLatency is set to Low, "Not Executable" is returned.
6)
Do not turn off the power of this unit before the response to the command is returned.
7)
In case that the power is turned off, the setting may not be reflected correctly. In such case, try to execute the operation using the
different setting value once, and then execute the operation using the correct setting value.
Command Packet
8x 01 06 01 VV WW 03 01 FF
8x 01 06 01 VV WW 03 02 FF
4)
8x 01 06 01 VV WW 01 03 FF
4)
8x 01 06 01 VV WW 02 03 FF
4)
8x 01 06 01 VV WW 01 01 FF
4)
8x 01 06 01 VV WW 02 01 FF
4)
8x 01 06 01 VV WW 01 02 FF
4)
8x 01 06 01 VV WW 02 02 FF
4)
8x 01 06 01 VV WW 03 03 FF
4)
8x 01 06 02 VV WW
0Y 0Y 0Y 0Y 0Z 0Z 0Z 0Z FF
8x 01 06 03 VV WW
0Y 0Y 0Y 0Y 0Z 0Z 0Z 0Z FF
8x 01 06 04 FF
8x 01 06 05 FF
8x 01 06 07 00 0W
0Y 0Y 0Y 0Y 0Z 0Z 0Z 0Z FF
8x 01 06 07 01 0W
07 0F 0F 0F 07 0F 0F 0F FF
Comments
VV: P an speed setting 0x01 (low speed) to 0x18
(high speed)
WW: T ilt speed setting 0x01 (low speed) to 0x14
(high speed)
YYYY: P an Position EC00 to 1400 (CENTER 0000)
ZZZZ: T ilt Position FB00 to 0500 (CENTER 0000)
W: 1 UpRight
YYYY: Pan Limit Position EC01 to 1400
ZZZZ: Tilt Limit Position FB01 to 0500
W: 0 DownLeft
YYYY: Pan Limit Position EC00 to 13FF
ZZZZ: Tilt Limit Position FB00 to 04FF

Command List