Power Backup Operation - Panasonic KX-TGE434 Operating Instructions Manual

2
MbN: Select the desired unit or "Voice
paging". a MSELECTN
R If you select "Voice paging", speak
into the microphone after the beep.
Your voice will be heard using the
speakers of the base unit
handsets, until a paged party answers
your page or until you press MOFFN.
After the other party answers, the
speakerphone mode is turned on.
3
When you finish talking, press MOFFN.
*1 KX-TGE440 series: page 3
Note:
R You can also use the MINTERCOMN soft
key, if displayed, to make intercom calls.
R You cannot use voice paging if other units
are in use.
R Voice paging is not available when a range
extender (KX-TGA405) is registered to the
base unit.
*1
Base unit
*1 KX-TGE440 series: page 3
1
Press MINTERCOMN.
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
2
When you finish talking, press MZN.
Answering an intercom call
Handset
1
Press M N to answer the page.
2
When you finish talking, press MOFFN.
*1
Base unit
*1 KX-TGE440 series: page 3
1
Press MZN to answer the page.
2
When you finish talking, press MZN.
For assistance, please visit http://shop.panasonic.com/support
TGE43xUS(en)̲0222̲ver231.pdf 21
Turning auto intercom on/off
This feature allows the handset or base unit to
answer intercom calls automatically when it is
called. You do not need to press M
MZN. When this feature is set to "On", the
*1
and all
monitoring handset or base unit for the baby
monitor feature (page 37) will also answer
baby monitor calls automatically. The default
setting is "Off".
1
For handset setting: MMENUN#273
For base unit setting (using a
handset)
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
*1 KX-TGE440 series: page 3
Note:
R This feature is not available for all handsets
paging and voice paging even if it is turned
on.

Power backup operation

When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. However, some
functions such as Caller ID and phonebook
are available only when using a handset other
than the handset supplying power to the base
unit. You can program "Power failure"
and the default setting is "Auto" (page 32).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Base no
power Press OFF" is displayed. After
pressing MOFFN on the handset, place it on
the base unit to start power backup mode.
R Power backup mode will not work if the
battery level of the power supplying
handset is
R Do not lift the power supplying handset
from the base unit during power backup
mode.
Making/Answering Calls
N or
*1
: MMENUN#*273
or .
2018/02/22 14:44:58
21