Mounting On The Wall; Support; Replacing The Batteries - Philips TSU9800 Starter Manual

TSU9800 Starter's Guide
7
Assemble the docking station again and screw the bottom plate back on.
The Control Panel is mounted and ready for use.

Mounting on the wall

When you mount the Control Panel on the wall, first
provide Ethernet connection and power supply
through the wall.
Although you can hang the Control Panel onto the
wall using just two screws, Philips provides a
mounting plate for an aligned, secure mounting.
You can order this separate accessory via your
distributor.
Note When you are not using the supplied adapter, make sure that you still have 5 Volt +/- 5% at the
end of the power cable. Especially when you are using longer power cables, the voltage level
may become critical.

Support

Replacing the Batteries

The batteries in the Control Panel are Lithium ion batteries. It is advised to change the batteries
when the autonomy of the Control Panel becomes noticeably less.
If you want to order new batteries, contact the Philips Service Center or your distributor.
For more information about the Service Center, please refer to Support on
http://www.pronto.philips.com.
Warning Replace the batteries in the TSU9800 only with the original Philips Pronto batteries;
otherwise the guarantee is no longer valid and hazardous situations could occur.
Tip The TSU9800 uses the same type of batteries as the TSU9600. These are the same spare parts.
Battery safety instructions
• Never dispose the cells in fire. This may cause the cells to explode.
• Do not spill liquids such as water or coffee on the cells.
• To prevent damage, use a tool to remove the batteries and do not pull the wires.
11