Effects Of Temperature - C&D Technologies LIBERTY 1000 Series Installation And Operating Instructions Manual

22
When the voltages of individual cells are lower than normal, it is
possible to conclude that insufficient charging has occurred.
The following are possible causes of cell voltage variations:
• Panel voltmeter reading high - This results in a low float voltage.
Re-calibrate the panel voltmeter.
• Poor intercell/inter-unit or terminal connections - If any
connection is found to be higher than 20% of the initial installation
values, disassemble and clean contact surfaces and reassemble.
• A temperature variation of more than 5°F (2.8°C) between cells -
Warmer cells drop to a lower voltage, because they require more
float current to keep them fully charged. Avoid exposing batteries to
external heat sources, which can cause temperature imbalance.

3.4 Effects of temperature

A lead-acid battery is an electro chemical device. Heat accelerates
chemical activity; cold slows it down. Normal battery operating
temperature is 77°F (25°C). Higher than normal temperatures have
the following effects on a lead-acid battery:
• Increases capacity
• Shortens life
• Increases internal discharge or local action losses
• Lowers cell voltage for a given charge current
• Raises charging current for a given charge voltage
• Increases the rate of dry-out of electrolyte
Lower than normal temperatures have the opposite effect and reduce
capacity. In general, at proper float voltage, a battery in a cool
location will last longer than one in a warm location.
Note: No temperature correction is required when operating at 77°F
+/- 10°F, (25°C +/- 5.5°C). The following correction factors
apply for a range not exceeding +/- 30°F from nominal. For
further
assistance with temperature correction factors, contact C&D
Technologies.
If the operating temperature is other than 77°F (25°C), it is recommend-
ed that the float voltage be changed as follows:
For temperatures other than 77°F (25°C), correct float voltage by 2
mV per degree F (3.6 mV per degree C):
• Add 2 mV (0.002 Volts) per degree F (3.6 mV per degree C) below
77°F (25°C)
• Subtract 2 mV (0.002 Volts) per degree F (3.6 mV per degree C)
above 77°F (25°C)
Note: Temperature compensation will materially improve battery
service life when provided.