Troubleshooting - AEG T6DB60378 User Manual

18 www.aeg.com

11. TROUBLESHOOTING

Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
The loading
door does not
close
It is not possible
to change the
programme or
option.
It is not possible
to select an op-
tion. An acoustic
signal is emit-
ted.
Possible cause
1)
The tumble dryer is not connected
to the mains supply.
The door is open.
The Ein/Aus button was not push-
ed.
The Start/Pause button was not
touched.
The appliance is in standby mode.
Incorrect programme selection.
The filter is clogged.
Trockengrad option was set to
4)
Bügeltrocken .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi-
tion.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possible
to change the programme or op-
tion.
The option you tried to select is
not available for the selected pro-
gramme.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do-
mestic installation).
Close the door.
Push the Ein/Aus button.
Touch the Start/Pause button.
Push the Ein/Aus button.
Select a suitable programme.
3)
Clean the filter.
Change Trockengrad option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi-
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
2)
5)
3)