Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
Vehicles with 4-cylinder engine:
Note
Bolt -2- secures the starter to the gearbox and has an addi‐
♦
tional spacer sleeve -arrow-.
The spacer sleeve must be fitted between starter and gearbox.
♦
– Move starter into installation position.
Vehicles with 4-cylinder TFSI engine or 6-cylinder TDI engine:
– Check that dowel sleeves -A- for centralising engine/gearbox
are fitted in the cylinder block.
– Join gearbox with engine (guide starter as appropriate).
– Screw in bolt -8- by hand until it makes contact.
– Install tunnel cross member
– Remove support bracket ⇒ Engine; Rep. gr. 10 ; Assembly
mountings; Supporting engine in installation position .
– Tighten bolts -1 ... 10-.
Vehicles with 4-cyl. TDI engine:
– Check that dowel sleeves -A- for centralising engine/gearbox
are fitted in the cylinder block.
– Join gearbox with engine (guide starter as appropriate).
– Screw in bolt -7- by hand until it makes contact.
– Install tunnel cross member
– Remove support bracket ⇒ Engine; Rep. gr. 10 ; Assembly
mountings; Supporting engine in installation position .
– Tighten bolts -1 ... 9-.
All vehicles:
Caution
Risk of vibrations or rattling noises when driving off.
♦ The work steps must be performed in the sequence shown
to ensure that the vibration damper is not under tension
when installed.
♦ The vibration damper must be flat on the drive plate when
the first securing bolt is screwed in.
– Turn crankshaft at vibration damper 360° in direction of engine
rotation.
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
⇒ page 74
.
⇒ page 74
.
2. Removing and installing gearbox
65