Ariens Sno-Thro 926 Service Manual page 18

Service Position
Figure 16
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be performed on a
regular basis. More frequent service may be required.
MAINTENANCE SCHEDULE
Service Performed
Check Dual Handle
Interlock
Check Fasteners
Check Clutch
Operation
Check Clutch Spring
Adjustments
Clean Engine
Check Engine Oil
Change Engine Oil
Check Tire Pressure
Check Auger
Gearcase
General Lubrication
Battery Maintenance
*
After first five hours of operation.
OS7120
**
After first two hours of operation.
CHECK DUAL HANDLE INTERLOCK
Without the engine running, press down (engage) both
clutch levers. Release attachment clutch lever.
Attachment clutch should remain engaged until traction
clutch lever is released, then both clutches must
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
CHECK CLUTCH OPERATION
Auger / impeller must stop within 5 seconds when
attachment clutch/impeller brake lever is released.
Wheels must stop quickly when traction drive clutch
lever is released.
If clutches do not engage or disengage properly, adjust
or repair before operation (see SERVICE AND
ADJUSTMENTS on page 23).
CHECK CLUTCH SPRING ADJUSTMENT
Make sure the attachment clutch and traction drive
clutch are adjusted to the range specified in
Attachment Clutch/Brake Adjustment on page 26.
CLEAN ENGINE
Refer to Engine Manual for detailed instructions.
GB - 20
Each Use Every 5 Every 25
hrs. hrs.
•
•
•
*
•
•
•
**
•
•
•
•
•
Yearly
•
•
•