M.2 Solid-State Drive; Internal Speaker - Lenovo ThinkCentre neo 50q Gen 4 User Manual

Note: After installing a new coin-cell battery, reset the system date and time in the UEFI BIOS menu.

M.2 solid-state drive

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Attention: The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data. When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not touch the contact edge of the M.2 solid-state drive. Otherwise, the M.2 solid-state drive might get
damaged.
• Do not apply pressure to the M.2 solid-state drive.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
For access, remove the following parts in order:
• "Top Cover" on page 30
• "Hard disk drive" on page 30
Removal steps

Internal speaker

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the top cover. See "Top cover" on page 30.
2. Disconnect the internal speaker cable from the internal speaker connector on the system board.
.
Chapter 6 CRU replacement
33